Page 1 of 1
Another newbie
Posted: Wed Sep 16, 2015 2:40 pm
by Aikman26
Hi all;
I've recently bought my Siii Coupe!
Over the moon with it thus far. I'm pretty handy with a spanner so I joined here to mine your wealth of knowledge.
Might even bestow some of my own
Re: Another newbie
Posted: Wed Sep 16, 2015 2:52 pm
by cervantes
Re: Another newbie
Posted: Wed Sep 16, 2015 3:02 pm
by Mike.Lawre
Re: Another newbie
Posted: Wed Sep 16, 2015 3:39 pm
by Rick
Hello and
to the forum.
Plenty of great information here. Search and ye shall find
Re: Another newbie
Posted: Wed Sep 16, 2015 4:03 pm
by Major
Re: Another newbie
Posted: Thu Sep 17, 2015 11:00 am
by Aikman26
Thanks for the welcome guys. My first port of call is going to be tracing that damn rear end rattle. It's driving me insane
Currently got the bootlid packed out with some sticky foam - doesnt seem to be that. Im guessing droplinks next.
- Have already checked all the obvious stuff like spare wheel tray, jack, drain tubes etc.
Re: Another newbie
Posted: Thu Sep 17, 2015 11:09 am
by thedupleman
Welcome aboard
Re: Another newbie
Posted: Thu Sep 17, 2015 11:11 am
by Rick
If its not the drop links try the ANTI ROLL BAR that goes from one side to the other as the rubber bushes on those go as well
These
- Anti_Roll_Bar_Bush_large.jpg (6.42 KiB) Viewed 5473 times
Saw one while I was at Sharkey's the other week and the droplinks were fine but these bushes were well knackered
Re: Another newbie
Posted: Thu Sep 17, 2015 11:42 am
by ChelseaBoy
Hi, and welcome.
Re: Another newbie
Posted: Thu Sep 17, 2015 11:25 pm
by jonward89
Hello and welcome aboard
Re: Another newbie
Posted: Fri Sep 18, 2015 9:23 am
by Xxxjayedxxx
Welcome
Re: Another newbie
Posted: Fri Sep 18, 2015 2:14 pm
by Aikman26
Thanks for the warm welcome guys
Cheers for the advice Dodge! I might nip along to the Hyundai dealer at the weekend and see if they'll put it up on the ramps for me.
Also FYI everyone I'm a design engineer - so if you need drawings done I'll be happy to help I'm also a dab hand with a soldering iron, PCB design, 3d printing etc
Re: Another newbie
Posted: Fri Sep 18, 2015 2:28 pm
by Tuscani TSIII
Welcome to the club.
I hope you are this much of a dab hand with the 3d printing
http://www.newtiburon.com/forums/exteri ... p-kit.html
Re: Another newbie
Posted: Fri Sep 18, 2015 6:15 pm
by Mr Tuscan
Welcome
Re: Another newbie
Posted: Fri Sep 18, 2015 7:40 pm
by s4mc0x
Hello & welcome to the club!
Re: Another newbie
Posted: Sat Sep 19, 2015 9:17 am
by ben.loader
Welcome mate.
