Page 1 of 1
I must say hello here!
Posted: Fri Jul 29, 2016 3:02 pm
by Mega
Therefore, Hello!
I am not a spambot, I'm in Maidenhead, near Windsor and just bought an old Gen 2 coupe for the princely sum of £220 ...
I may have questions such as what clutch it needs and why is it on fire, time will tell.
So hello there!
Dave
Re: I must say hello here!
Posted: Fri Jul 29, 2016 3:09 pm
by Mike.Lawre
Re: I must say hello here!
Posted: Fri Jul 29, 2016 3:31 pm
by Shel
Re: I must say hello here!
Posted: Fri Jul 29, 2016 5:29 pm
by Rick
Hi Dave and
to the forum
Re: I must say hello here!
Posted: Fri Jul 29, 2016 9:32 pm
by GlasgowG
Re: I must say hello here!
Posted: Fri Jul 29, 2016 10:07 pm
by Mr Tuscan
Welcome
Re: I must say hello here!
Posted: Fri Jul 29, 2016 10:39 pm
by fiddly bad
Re: I must say hello here!
Posted: Sat Jul 30, 2016 6:47 am
by Nyx1962
Re: I must say hello here!
Posted: Sat Jul 30, 2016 4:24 pm
by thedupleman
Welcome nice to see you here. Wasted your time signing up for ukhcc as you will soon see!
Re: I must say hello here!
Posted: Sat Jul 30, 2016 9:23 pm
by Tiswas
Re: I must say hello here!
Posted: Mon Aug 01, 2016 5:10 pm
by jonward89
Welcome to the club
Re: I must say hello here!
Posted: Mon Aug 01, 2016 6:51 pm
by nissan300zx
hi mate and
to hcoc.
Re: I must say hello here!
Posted: Mon Aug 01, 2016 7:40 pm
by Mega
Cheers! Nice bunch!
So my car is a bit rough, but I'm enjoying her so far ...
I'll get some pics up as soon as I can!
I'm looking to clean her up a touch so want to respray the front bumper which is fecked (Needs a bit of a fill, good key and then a spray down.
Also looking at the timing kits for the gen 1 and there seems to be loads, will put a post up asking for recommendations there, the DOHC belt setup has me a little confused at the minute mind.
Equally going to sort brakes and tyres out when I can :-) At least the little 15s are cheap compared to what I'm used to !!!
Thanks everyone again for the warm welcome. I like it here :-)
Re: I must say hello here!
Posted: Mon Aug 01, 2016 7:41 pm
by Mega
thedupleman wrote:Welcome nice to see you here. Wasted your time signing up for ukhcc as you will soon see!
Haha!!! Yeah, I signed up on the top two links, and have no particular preference - but I have had a nicer welcome here ...
I don't know if you're posting in jest/irony or serious so I'll withhold further comment.
But thanks for the welcome :-)
Re: I must say hello here!
Posted: Mon Aug 01, 2016 8:07 pm
by thedupleman
Have you had a look how dead it is on there? Weeks without a post. Totally serious
Re: I must say hello here!
Posted: Mon Aug 01, 2016 8:34 pm
by robbo
Mega wrote:Also looking at the timing kits for the gen 1 and there seems to be loads, will put a post up asking for recommendations there, the DOHC belt setup has me a little confused at the minute mind.
Thanks everyone again for the warm welcome. I like it here :-)
Welcome to the club
The cambelt only drives the exhaust cam, there's a timing chain on the other end that links the exhaust and inlet cams together
Sent from my iPhone using Tapatalk
Re: I must say hello here!
Posted: Mon Aug 01, 2016 9:55 pm
by Snake
Welcome on board Dave.
I tried the other forum too .... not much happening at all ... i didn't even post a hello I was that unimpressed..
found the right one here .. much better, friendlier, knowledgeable and lots of information knocking around in the archives to read through.... I'm happy!.
Re: I must say hello here!
Posted: Tue Aug 02, 2016 11:22 am
by mag1967
Welcome